Quantum Forum V

Quantum Forum for DXi V5000

Troubleshooting your 123.hp com/setup officejet pro 6800 When it Fails to Pick Up Paper

One of the problems facing 123.hp com/setup officejet  pro 6800 users is that the 123.hp com/ojpro6800 printer fails to take paper. It is also possible that the printer is picking up several papers from the printer tray. If you are in the middle of an important task then these problems can cause you a lot of discomfort. Thus, to fix the issue some things need to be kept in mind if it appears while working. Below are some suggestions to eliminate the system and fix 123.hp com/oj6800 printer problems.

If the 123 hp com /office jet pro 6800 printer does not pick up the papers, you can take the following steps and try to work.

  • First, open the 123.hp.com/oj6800 printer and eliminate the jammed sheets of paper, if any. Make sure there are no residues of torn paper in the tray or inside the printer.
  • Load the tray with the exact size of paper that is allowed.
  • Check whether the size and type of paper is correctly adjusted on the 123.hp.com/ojpro6800 printer's control panel.
  • Make sure that the paper guides in the tray are correctly marked for the size of the paper. Check and adjust the guides in the direction of the correct markings on the tray.

pay attention

Make sure that you do not adjust the paper guide towards the paper stack. Always adjust them for precise indentation on the tray.

Check again if room humidity conditions follow specified limits. 123 hp com /office jet pro 6800 It is necessary to keep the papers in a dry environment to avoid spoiling them. They are usually sold in moisture-proof wrapping.

You also need to verify that the humidity in the room is within the specifications for this 123.hp.com/officejet pro 6800 all in one printer and that paper is being stored in unpacked packages. Most places of paper are sold in moisture-proof wrapping to dry the paper. If the paper is exposed to a certain level of moisture, it is possible that the paper absorbs the moisture. If this happens, you should remove the top 5 to 10 sheets of paper from the bundle of paper.

 

Paper pickup error

Further more, if the papers are placed in an area with low humidity, they are bound to create static electricity over time, from which they clump together. If this happens, you must first remove the papers from the www.123.hp.com printer. Then flex the stack by pressing it firmly on both ends and using your hands to make you shape, bring the ends upward. Once you do this, do it in the reverse direction, and do another one. Now, shift the sides and fold the paper in your hands. Now the long hand is in your hand. Flex the sides upwards to create another U. Repeat the same in the reverse direction.

Follow other verbs

  • See if the printer remains offline; Ensure that you are online while using it.
  • Ensure that the 123.hp.com/ojpro6800 printer control panel is indicating to feed the paper in manual mode. Then load the paper and continue.
  • It is also possible that the rollers above the tray are contaminated. Clean it with a lint-free cloth dipped in warm water. If possible, try using distilled water for this purpose.
  • There is a possibility that tray rollers may be worn. Go ahead and inspect the rollers for the appearance of a smooth surface around the entire circumference. Sometimes, only one side is worn, so make sure you test it thoroughly.
  • If there are smooth areas, you should check the supply status page and see if the fuser (maintenance kit) is running low and whether it needs to be replaced. These rollers arrive with the kit.
  • Replace tray rollers if necessary.

If the 123.hp.com/setup printer picks up several sheets of paper, you must also run the following checks.

Tags:-

 

123.hp com/oj6800 , 

123.hp com/ojpro6800 ,  

123.hp com/setup officejet  pro 6800 , 

123 hp com /office jet pro 6800 , 

123.hp.com/ojpro6800 , 

123.hp.com/oj6800 , 

123.hp.com/officejet pro 6800 all in one printer , 

www.123.hp.com 

123.hp.com/setup.

 

Views: 1

Comment

You need to be a member of Quantum Forum V to add comments!

Join Quantum Forum V

Tips + Tricks

© 2024   Created by Quantum Forum V.   Powered by

Badges  |  Report an Issue  |  Terms of Service