how to program a 2 channel sherlo receiver
sherlo remote receiver
sherlo rx2-100 manualsherlo 4 channel receiver manual
how to clone a sherlo remote
sherlo 1 channel transmitter
sherlo serial texecom receiver manual pdf
sherlo 2 channel receiver manual

2-Channel Receiver: 150m Code-Hopping. Model No: RX2-150 1. Select the Relay channel you would like to default. You do this by removing the shunts off Sherlo 1 channel receiver Master remote program receiver Contact no/nc and latching Required power 12Vdc - 24Ac required 150 meter range in idealthe Receivers memory reaches its 64 remote limit while in progam mode, the unit will sound a Long beep when it receives a signal and then will auto exit from Press the LEARN switch once to step to relay 1. (1 x beep sounds) · Press the button on the remote control a few times to learn in to the receiver. · Continue to IEC 60950-1:2005 + A1:2009. Model No: RX1-150. 1 Channel Receiver : 150m Code Hopping. Approvals: Installation Instructions - For Service Persons Only. This section explains how to delete all programmed remotes from the unit. This should be done in the event of a loss of one or more of the remote controls for IEC 60950-1:2005 + A1:2009. Model No: RX1-500. 1 Channel Receiver : 500m Code Hopping. Approvals: * (pending). Installation Instructions - For Service