Quantum Forum V

Quantum Forum for DXi V5000

Setup DXI as NFS?

I'm prepping this to be a Veeam repository and I understand that NFS is much faster than CIFS.

How do I set a username/password to offer up to Veeam to access the NFS based shares I created?

Views: 118

▶ Reply to This

Replies to This Discussion

Permalink Reply by Jerry Schmidt on July 1, 2016 at 10:39am

Hello Seth,

I have attached Quantum's Best Practices for Veeam. Page 8 covers the NFS configuration steps.

Attachments:
Permalink Reply by Seth Zwicker on July 2, 2016 at 4:35am

Thanks.  Since my original post, I've managed to stand up a linux VM and mount the NFS share on the DXi VM to it and then add it in Veeam.  The issue, now, is that the repository in Veeam only shows it as being 30GB in capacity.  Where is that number coming from?  I've licensed the DXi appliance so it should have a TB available.

Permalink Reply by Seth Zwicker on July 2, 2016 at 3:06pm

Figured out the issue. 

thx

Permalink Reply by Jerry Schmidt on July 5, 2016 at 8:20am

If you have time, can you advise of the resolution you implemented?

Permalink Reply by Seth Zwicker on July 5, 2016 at 10:33am

It wasn't an issue with the quantum appliance.

My Linxu VM mount wasn't properly in place so it was just using the local drive, which had 30GB.

Permalink Reply by Ashwani on December 27, 2019 at 2:11am

Hello,

I am trying to implement the DXi V1000 and get it linked with Veeam Backup and Replication.

After successful implementation, i am not able to install the licence of Veaam on Dxi V1000. I have visited the Licence page of quantum and pasted the Serial number of dxi v1000, but it showed no licence key.

Waiting for your reply!.

Thanks

RSS

Tips + Tricks

© 2024   Created by Quantum Forum V.   Powered by

Badges  |  Report an Issue  |  Terms of Service