Quantum Forum for DXi V5000

Problems when configure by first time Dxi V5000

Hi everyone:

I'm new and I'm installing a Dxiv5000 on my vmware infrastructure and i have the following problems:

After login by first time, appairs a message on Service Tickets that says: "DXiV5000: General DXiV5000 Software DART.service : Operation failure"
In the same console, the system is on Diagnostic mode and limite mode.
When I make the changes in the network configuration, when I restart it no longer allows me to enter the web console. I get a 503 POST/Authentication error, despite having changed the credentials.

I hope your help to solve this.

Regards,

1 member likes this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Steve Wright on April 24, 2023 at 7:35am

I haven't seen anything quite like this. Have you resolved any of this since posting? Any luck?

▶ Reply

Permalink Reply by Jorge on May 17, 2023 at 4:06pm

Hi Steve:

I was trying some ways, I thought it was a mistake because I was using a wrong hypervisor (it used esxi 6.5 when the requirement indicated 6.7). However, it happened again.

I have made some attempts, deleting the vm and re-importing the ova file and the same error is repeated.

Regards,

▶ Reply

Permalink Reply by Jorge yesterday

Update:

I think that some services do not finish starting when the VM starts. For example, DART is one, sometimes it says that it doesn't start my_generic.target and also in a last attempt it was the heathcheck.service.
Is there a way to see why this is happening?

Problems when configure by first time Dxi V5000

Replies to This Discussion

Tips + Tricks