Quantum Forum for DXi V5000
Problems when configure by first time Dxi V5000
Hi everyone:
I'm new and I'm installing a Dxiv5000 on my vmware infrastructure and i have the following problems:
- After login by first time, appairs a message on Service Tickets that says: "DXiV5000: General DXiV5000 Software DART.service : Operation failure"
- In the same console, the system is on Diagnostic mode and limite mode.
- When I make the changes in the network configuration, when I restart it no longer allows me to enter the web console. I get a 503 POST/Authentication error, despite having changed the credentials.
I hope your help to solve this.
Regards,
Replies to This Discussion
-
Permalink Reply by Steve Wright on
-
I haven't seen anything quite like this. Have you resolved any of this since posting? Any luck?
-
Permalink Reply by Jorge on
-
Hi Steve:
I was trying some ways, I thought it was a mistake because I was using a wrong hypervisor (it used esxi 6.5 when the requirement indicated 6.7). However, it happened again.
I have made some attempts, deleting the vm and re-importing the ova file and the same error is repeated.
Regards,
-
-
Update:
I think that some services do not finish starting when the VM starts. For example, DART is one, sometimes it says that it doesn't start my_generic.target and also in a last attempt it was the heathcheck.service.
Is there a way to see why this is happening?Regards,
-
-
Update:
I found a detail, I increased the memory (it was 4GB and I raised it to 6) and when turning on the VM, the system changed to Normal state. I couldn't get into the GUI console anyway but I can get in via CLI and configure. After I shut down the VM, I returned the RAM to 4 GB and at startup it returned to diagnostic status.
© 2024 Created by Quantum Forum V.
Powered by
