Quantum Forum for DXi V5000
Backup waiting to start...
Hi there.
I have successfully run an initial backup of a number of VM's in a folder that are set for multiple copies.
This first run did a full backup of each VM and subsequent VM's should be partial as CBT is enabled.
However when I run the backup for a second time the status just says "Backup waiting to start...".
There is nothing to suggest anything is wrong in any of the logs (I particularly check the controller and smartmotion logs) but the jobs never actually runs.
Can anyone advise what may be misconfigured / wrong ?
Thanks very much.
Replies to This Discussion
-
Permalink Reply by Whip Hubley on
-
Hmm, I was about to re-start the vmPRO application (essentially by restarting the VM it runs on) and thought I'd run a config backup first.
When I do so I see this on the webpage which I attempt to download the file from...
"error_message": "Error during database dump creation", "error_code": -1
And this in the controller log...
2013-09-25 16:54:00: WARNING: Could not acquire lock for configuration package creation
I'm guessing to run backup jobs there need to be database access - and for some reason this cannot be achieved.
Could that be the cause of the issue ?
© 2024 Created by Quantum Forum V.
Powered by
