Delta created their shower controls with integrated diverter to make operating a large shower head with hand sprayer system easy! An integrated diverter control merges the mixing valve and trim kit, and the diverter valve and trim kit, into a single unit. Rather than having two separate valves to install, you'll only have one. For easy installaton of your Delta® shower unit you will need to: READ ALL the instructions completely before beginning. READ ALL warnings, care, and maintenance information. Purchase the correct water supply components. (All Documents are Printable) Caring for a shower door is relatively simple. Step 1: Clean the Shower Arm if Needed. Inspect the old shower head. If you see any rust or other mineral deposits on the connection between the shower arm (the metal pipe connecting the shower head to the wall) and the shower head, use a rust remover on it. This will make unscrewing the old shower head easier. Step 1: Shut Off Water Supply And Remove The Plaster Guard. Turning off your water supply is the first step when installing a Delta shower faucet. Most showers don't have one supply valve, and as such, it is essential to completely turn off the main home water supply. Once you've turned down your water supply, you'll need to remove the • Shower opening dimensions: - 60" Tub/shower: 50-1/8" minimum to 59-3/8" maximum. - 48" Shower: 43-3/8" minimum to 47-3/8" maximum. • Walls must be within 3/8" (10 mm) of plumb. • Cover tub or shower drain with rag or tape to avoid loss of small parts. • Follow the silicone sealant manufacturer's instructions for application and This item: Delta Faucet Single-Spray Shower Head, Chrome 75155. $14.77. In Stock. Ships from and sold by Amazon.com. Backed with a lifetime warranty and easy-to-follow installation instructions, the Delta Water Amplifying showerhead is sure to bring showering pleasure and savings for years to come. The Alsons story began in 1958, with Hannah shows how to install a Delta® 4-Setting HydroRain® shower head. 49 Views • May 13, 2022 • Knowledge How to Install a Delta® 7-Spray SureDock™ - Video Install Hand Shower a. Place the hose washers into the hose nuts on each end of the hose. b. Attach the end of the hose with a hex nut to the shower head. Connect the other end of the Metal Hose to the Hand Shower. All connections should be able to be made by hand tightening only. c. Touch-clean® Shower Heads - wipe the face of the shower head (rubber nubbins) to loosen and break away deposits. Learn more about Touch-clean. Non Touch-clean shower heads or stubborn deposits - unscrew the shower head and soak it in a 50/50 vinegar and water solution for several hours. For stubborn deposits, rub with a toothbrush. Apply a small amount of Teflon tape to the threads on both sides of the shower arm. Insert the longer side of the shower arm through the wall and into the elbow connection on the water supply pipe. Twist clockwise to tighten. If you cannot sufficiently hand-tighten the shower arm, wrap it in a thick towel before using an adjustable wrench to First, remove the shower head and unscrew the retaining ring. This will expose the washers. Remove the old washers and replace them with new ones. Screw the retaining ring back on and reattach the shower head. Replacing the shower head. If the shower head is cracked, it will need to be replaced.