Section B. Mentor Graphics De sign Architect (DA) tutorial In this tutorial, we are going to use Mentor Graphics Design Architect (DA) tool to design a schematic circuit of 2-input NAND gate. 1. Log into a Mentor-capable machine. Open a terminal console window. Input the following command: da You will see the main interface of DA tool shows up. The Design and Simulation of an Inverter (Last updated: Sep. 1, 2010) Check that the layout view and schematic view match using Mentor Graphics Calibre LVS, a The image below shows the final schematic that we will make in this tutorial. Fig. Inverter schematic Mentor Graphics OPAMP Simulation Tutorial --Xingguo Xiong In this tutorial, we will use Mentor Graphics tools to design and simulate the performance of a two-stage OPAMP. The two-stage OPAMP is shown below, which comes from section 5.1 of the book by Johns and such drawing in Schematic • Drawing the schematic, we use the component from two libraries which are accessed through the Libraries entry at the top of the Design Architect window. • For Logic devices we use the models from Logic Modeling Corporation. •For Vcc, ground, portin and portout connectors we use Mentor Graphics misc_lib. Starting Mentor Graphics' DxDesigner for the First Time (Engineering 163 - Fall 2004) draw.ini file with your preferences for schematic drawing conventions. I have set Graphics/Mentor Graphics SDD/The MGC SDD Configurator. INTRODUCTION TO MENTOR GRAPHICS DESIGN TOOLS 7- Creating schematic of NAND3: Right click nand3 in the Cell pane, and select "New View". To zoom in, hold down the middle-mouse button and draw a diagonal red line to indicate the area you want to zoom into. To zoom out, press the magnifying Here's a few scripts I've written to help me with PCB design while using Mentor Graphics' PADS: put notes that schematic users might find useful as text on the schematic (as this will probably be you) draw silkscreen in each part showing the actual border of the part (us